Professional Roofing Services in Clermont, FL

Initial Inspection and Scope Documentation

We begin with a roof inspection that documents existing conditions in sufficient detail to answer three questions: what damage or wear exists, whether repair or replacement is the appropriate response under Florida Building Code, and what the insurance carrier will require for continued coverage. Our crews photograph every plane, every penetration, every valley and ridge. We measure square footage, note shingle granule loss, check flashing integrity at chimneys and vent pipes, and look for lifted edges, algae staining, and underlayment exposure. Inspections are free when paired with a repair or replacement quote. We respond within 24 hours.

Material Selection and Manufacturer Certification

We install GAF asphalt shingles, Owens Corning shingles, CertainTeed shingles, standing seam metal roof systems, 5V Crimp metal roofing, corrugated metal roofing, metal shingle roofs, metal tile roofing, aluminum roofing, galvanized steel roofing, Galvalume steel roofing, stone-coated steel roofing, clay tile roofs, concrete tile roofs, TPO roofing systems, EPDM roofing, and modified bitumen roofing. For a typical 1500 square foot home in Florida, architectural asphalt shingles run approximately $7,500 to $12,000, while standing seam metal costs between $14,000 and $25,000, and tile roofing starts around $18,000. Asphalt shingles offer the lowest installed cost per square foot and a warranty period of 25 to 30 years. Metal roofs carry a lifespan of 50 to 70 years, and many insurers offer premium reductions averaging $800 to $1,600 annually for homes with metal roofs. Tile roofs are known for their longevity, low maintenance, and distinctive appearance. They can last 50 years or more with proper installation and care.

Our GAF Master Elite certification requires annual training, factory inspections of our installation practices, and maintenance of consumer complaint resolution standards that fewer than 2 percent of North American roofing contractors meet. The same applies to our Owens Corning Preferred Contractor status. These are not awards. They are audited operating requirements that let us offer extended manufacturer warranties covering both material defect and workmanship, a combination unavailable from non-certified installers.

Permit Application and Building Department Coordination

We handle permit services for every project requiring one. In Lake County, building permit fees range from $200 to over $1,000 depending on location and project scope, according to published guidance. We submit engineered drawings where wind uplift calculations are required, coordinate inspection scheduling with the local building department, and ensure all work halts at the appropriate stages for inspector sign-off. Dan Trombley wrote in a review, "Roof passed inspection without a problem." That outcome reflects advance coordination, not luck.

Tear-Off, Decking Repair, and Underlayment Installation

Where full replacement is required, we remove the existing roof down to the decking. Our crews inspect every sheet of plywood or OSB for rot, delamination, or fastener pull-through. Compromised sections are cut out and replaced with new decking meeting current fastening schedules. We install synthetic underlayment across the entire roof deck, lapping seams per manufacturer specification, and apply self-adhered ice and water shield in valleys, at eaves, and around all penetrations. Underlayment is the second line of defense. Shingles are the first. Both matter.

Shingle, Tile, or Metal Panel Installation

For asphalt shingles, we begin at the eave with a starter strip, then lay courses with the offset and exposure specified by the manufacturer. Each shingle receives the required number of fasteners, placed in the nailing zone, driven flush but not overdriven. We install step flashing at sidewalls, counter-flashing where chimneys meet the roof plane, and pipe boots at every vent penetration. Ridge vents run the length of the peak to provide attic ventilation, critical in Florida's heat and humidity. For metal roofing, we fasten panels to the decking with concealed clips on standing seam systems or exposed fasteners with neoprene washers on 5V and corrugated profiles. For tile, we install battens, secure each tile with mechanical fasteners, and seal the hips and ridges with mortar or foam closures to prevent wind-driven rain intrusion.

Final Inspection and Warranty Registration

Once installation is complete, we schedule the final building department inspection. The inspector verifies fastening patterns, flashing details, and overall code compliance. After approval, we register the project with the shingle or metal manufacturer to activate the material warranty and document our workmanship coverage. We offer roof warranties that range from 25 to 50 years, depending on the material and the manufacturer program selected. We provide one copy of all permits, inspection approvals, and warranty certificates to the homeowner. These documents are what the insurance underwriter will request at renewal.

Storm Data and the Case for Disaster-Resistant Materials

Florida has experienced 94 confirmed weather and climate disaster events with losses exceeding $1 billion each between 1980 and 2024, according to NOAA National Centers for Environmental Information. Most metal roofs are rated to withstand winds up to 150 miles per hour, the equivalent of a major Category 4 hurricane and an F2 tornado. Category 4 Hurricane Ian made landfall near Cayo Costa in September 2022 with sustained winds of 150 mph, delivering $119.6 billion in damage and 152 deaths. The choice of roofing material is not aesthetic. It is structural risk mitigation quantified by wind rating, impact resistance class, and the insurance premium reduction the carrier will grant once installation is verified.

What Our Customers Report

"Installed new metal roof. Roofers were professional. Management of project by Rich DeCola was excellent. Roof passed inspection without a problem."

Dan Trombley

Roofing Service Area in Clermont and Central Florida

We serve Clermont, Lake County, Minneola, Groveland, Four Corners, Windermere, Winter Garden, and Orlando. Our crews operate from a central dispatch in Central Florida, and all 48 employees work directly for Roof Bear. We do not subcontract installation, repair, or inspection work. Every person on your roof carries our license and our insurance.